![]() You would have to change the AEBSn's 2.4 GHz radio to use one of the 802.11g modes in order to establish the WDS. Which would give it the best range?Ī WDS can only operate on the 2.4 GHz band and with 802.11g. You can also "force" the client to either radio by naming the 5 GHz network with a different Network Name than that used by the 2.4 GHz radio. typically choosing the radio with the strongest signal. If, for example, you configure your AEBSn for: 802.11n only (5 GHz) - 802.11n only (2.4 GHz), 802.11n clients could connect to either radio. Unlike the other Wi-Fi standards, 802.11n can operate on both the 2.4 & 5 GHz radio band. I thought it would mean that N only can go on 5ghz when available and the right side of the dash would mean 2.4ghz of b/g/n if 5ghz is not available. ![]() The 5 GHz radio mode is represented on the left of the dash and the 2.4 GHz radio mode is represented on the right. I would suggest that you first get the AEBS setup and functioning correctly before trying to configure the AirPort Express to extend the network. I can provide detailed step by step configuration instructions, and the network I am using now is quite similar to yours, but sometimes misunderstandings occur with instructions and it may be necessary to back track a few steps in order to move forward. If the AX cannot be located where you would like it to be, would a different location still meet your requirements? You likely have a location in mind for the AX. To do so, it must receive a strong enough wireless signal in order to be able to extend it. The AirPort Express (AX) can extend a wireless signal from an AEBS. In some installations, you almost need line-of-sight between a router and devices when using 5 GHz.ĭo you understand that you may not receive the results you seek with 5 GHz because the signal may not penetrate as well as the lower speed 2.4 GHz signals? Would the lower speed "n" at 2.4 GHz meet your requirements if you are unable to use the higher speed "n" 5 GHz settings? In reality, 5 GHz signals are absorbed by walls, ceilings and any obstructions much more quickly than 2.4 GHz signals. The 5 GHz setting will allow more speed on your network.in theory. One operates at 2.4 GHz and the other at 5 GHz. There are two types of "n" only networks. Do you understand that if you have any "g" devices like an iPhone, iPod, or older computers that these devices will not be able to connect to your AEBS wireless network? Will this meet your requirements? You state that you want to create an "n" only network with the AEBS and extend it with the AX. So, you will be creating a single wireless network with the AEBS which can be extended by the AirPort Express (AX). This is the correct setting for the AEBS in your type of configuration with the Fios router.ĭo you understand that it is not possible to configure dual-band networks on the AEBS when it is in bridge mode? The reason for this is that the "guest" network is not active when the AEBS is set to bridge mode. Some comments and questions so that things will get started down the right path and your expectations are met.Īccording to the information in your post, you have the AirPort Extreme (AEBS) set up with the Connection Sharing set to "Off (Bridge Mode)".
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |